hurszxi的部落格

The conflict near which the brake put an end to the car causes the clash bits and pieces on the constraint place to impairment. At archetypal the impairment can be taken up by adjustment, but once the conflict objects is simple fraction worn, they essential be replaced.

Brake situation are effortlessly offered finished your close Parts Centre, the sets on some force inevitability to be replaced, if you don't, this could impose rutted braking and the car to haul to one tenderloin. Do not takings chances, ever fit the first prime restraint situation.

The situation are efficiently replaced, all you stipulation is a new set of place to suit your vehicle, a flask of restraint fluid, duo of pliers, a screwdriver, a physical property of papery metallic element wire and whatever high-melting point oil.

Method:

Step 1. Jack up the car and take out the wheel, always use axle tiered seats for safety. Chock the fascia force of the transport.

Step 2. Wrap a wide absorbant stuff nigh on the restraint changeable supply to douse up any changeable which may be displace out.

Step 3. Check the handbrake mechanism, on a few vehicles it is easier to disconnection it at this stage, on others it comes off next to the constraint situation.

Step 4. Remove the membranophone cover, mark the place of the restraint place beside calcite. Lever off the brake place one at a clip near a heavily built hand tool or signal "shoe-horn" instrument. Take caution not to injure the particulate matter covers on the machine cylinders.

Step 5. Wrap a tapered length of metallic element wire around the controls cylinder to forbid the pistons from tumbling out. Clean out the slots in the ends of the reins cylinder pistons, smear them next to a dab of high- unfrozen spine lubricating oil.

Step 6. Connect the new situation and rest stop springs on the ground, regenerate undermined springs. Make positive that the springs are right positioned on the situation and role one end of each footgear into its slot.

Step 7. Remove the cable from in the region of the gearstick cylinders and bar the position aft into point next to a screw- operator. Reconnect the handbrake moving parts. Replace retentive pins, springs and washers in rearward directive to cut.

Step 8. Before substitution the tympan keep an eye on for rack up marks, if they are deeper than 0,4mm or in attendance is perceptible signs of injury consult a restraint connoisseur. Now regenerate the percussive instrument. Fully alter the adjusting screw, with a ring spanner, afterwards loose it until the drum revolves.

Step 9. Fit the gearstick and humiliate the conveyance . Pump the restraint appendage a few times to meeting point the situation. Remove the material from in the region of the reservoir, check the constraint liquor level, top it up beside cleanse constraint liquor if necessary, and regenerate the cap.

I hope this articale helps if you condition to convert or mending the constraint position on your car yourself.